W5100S-EVB-Pico2 is a microcontroller evaluation board based on
the Raspberry Pi RP2350 and fully hardwired TCP/IP controller W5100S –
enhancing the capabilities of the traditional Raspberry Pi Pico board with
additional Ethernet functionality via W5100S.
·
Enhanced Raspberry Pi Pico Clone
·
Ethernet (W5100S Hardwired TCP/IP CHIP)
Features
·
RP2350 Microcontroller with Integrated 16Mbit Flash
·
Symmetric dual Arm Cortex-M33 cores at up to 150MHz
·
520kByte multi-bank high performance SRAM
·
External Quad-SPI Flash with eXecute In Place (XIP) capabilities
·
Enhanced performance full-crossbar bus fabric
·
Up to 48 multi-function General Purpose IO (8 can be used for
ADC on RP2350-B)
·
1.8-5.0V IO Voltage
·
W5100S Ethernet Controller
·
Supports Hardwired Internet Protocols: TCP, UDP, WOL over UDP,
ICMP, IGMPv1/v2, IPv4, ARP, PPPoE
·
Supports 4 Independent Hardware SOCKETs simultaneously
·
Internal 16 Kbytes Memory for TX/ RX Buffers
·
High Speed Serial Peripheral Interface (SPI MODE 0, 3)
·
Analog and Digital Peripherals
·
12-bit 500ksps Analogue to Digital Converter (ADC)
·
Advanced digital peripherals including:
·
2 × UART, 2 × I2C, 2 × SPI, 16 × PWM channels
·
1 × Timer with 4 alarms, 1 × Real Time Counter
·
3 × Programmable IO (PIO) blocks, 12 state machines total
·
Flexible, user-programmable high-speed IO
·
Can emulate interfaces such as SD Card and VGA
·
Connectivity
·
C-Type USB port for power and data (and for reprogramming the
Flash)
·
40 pin 21×51 ‘DIP’ style 1mm thick PCB with 0.1″ through-hole
pins also with edge castellations
·
3-pin ARM Serial Wire Debug (SWD) port
·
Networking
·
10 / 100 Ethernet PHY embedded
·
Supports Auto Negotiation
·
Full / Half Duplex
·
10 / 100 Based
·
Built-in RJ45
·
Power Supply
·
Built-in Switch-mode DC-DC converter (replacing LDO for enhanced
power efficiency)
No review given yet!